QUESTION:
I am working on a 4” Wilkins model number 350ASTDA. Can you give me some background about this assembly and explain how to service the check valves?
MARK:
The Wilkins 350ASTDA is a double check detector assembly (DCDA). It is available in 2 1/2″-10″ sizes and has been in production since 2011. The body is made of stainless steel. The 350ASTDA utilizes a 3/4″ 950XLD for the bypass assembly. The repair procedures for the 350ASTDA series are similar to the 350ADA series, but it is important to note that the internal parts are different and do not interchange. No special tools are needed to repair this assembly.
DOUG:
The 350ASTDA has a single access cover. The cover is secured by a grooved coupling and there is no spring load. This assembly has check valves that are modular in design and are sometimes referred to as “compound checks.” The springs are completely contained and the check valve modules are secured by retainers and o-ring sealed into the device body. Note: The first check must be removed before the second check can be removed. To service the checks they must be removed from the device. You will notice that the first check has a plastic ring retainer. The tabs for the retainer are exposed in the 12 o’clock position. Simply pinch the tabs together, push down, and then pull downstream. The check can now be removed by pulling it straight out of the body.
MARK:
Once the first check is out, we can remove the second check. The second check is secured by two separate spring loaded plate retainers. They are located at the 12 and 6 o’clock positions. Pinch the sides of the spring together and rotate the plates out of the body groove, one at a time. The second check can now be removed by pulling it straight out of the body. Now that the modules have been removed, we must disassemble them to access the check discs. Note that the spring tension is contained when the check is taken apart. Be cautious to not remove any hardware from the spring side of the module. The downstream side of the check will have 4 hex head bolts that need to be removed. Once they have been removed, you can separate the disc retainer from the module and the disc is free to be replaced. It is also important to inspect the seat. The seat is an integral part of the check module, so if there is any damage the entire check must be replaced.
DOUG:
Once that service has been completed, simply reassemble each module in reverse order. As you reinstall the checks into the body, make sure the rollers are positioned at 3 and 9 o’clock so they will not get in the way of the retainers. Install the plastic retainer for check valve #1 by inserting one end into the body groove and then sliding your hand around the face of the retainer pushing it into the groove as you go. It will snap into place when it is fully seated. Install each of the wire retainers for check valve #2 into the body groove, one at a time. Pinch the sides of the spring together and rotate the plates into the body groove.
